How to Deflate a Basketball – The Complete Guide

Now that you know how to break into your basketball shoes properly, it’s time for some techniques for reducing the air out of the basketball. 

Basketballs are more expensive now than ever in history. Taking care of the basketball can save you money later on.

Sometimes we might need our basketball deflated, like if they get wet or dirty and can’t be cleaned; this will cause them to not hold any more pressure than necessary — which is where I come in! This complete guide teaches all about deflation and also includes instructions.

What’s the Point of Deflating a Basketball…


What Is the Point of Deflating a Basketball?

Deflating a basketball is not something you ever expect to do, but if it happens, then there’s no time like the present to get the job done.


One of the main reasons to take the air out of a basketball is if it had been overinflated. A basketball that’s too airy will make the game more difficult, and its bounce can be uncomfortable for both players and viewers alike!

At first, you might think that dribbling a basketball is easier than passing and shooting, but you’ll lose your grip on the ball due to its high bounce. This makes it difficult for players like yourself who are just starting because they’re not used to all these new techniques yet!

You might be wondering how your basketball became so inflated, and the answer is most likely that you or some other person must have pumped extra air into it. However, if the basketball was sitting out in a hot sun (hopefully that didn’t happen), the warmth from the sun could also cause the inner air pressure to rise. 

You might not know this, but the air pressure inside your basketball changes with temperature and altitude. Cold air lowers the inner pressure, warm air raises it. 

If you pumped air into your basketball properly on a frosty day only to come back later when things were warmer because of summer temperature changes, you may find the basketball to be overinflated as a result. You might see a similar thing happen with bicycle and car tire air pressure in relation to temperature changes. 

Storage and Transport

When storing or transporting a basketball, it may be important to shrink your basketball so that it fits better in drawers with more room for your clothes. You can save money on closet cleanouts by doing this!

Be careful when deflating the basketball. Deflate it gently and monitor how your deflatables are responding so that you don’t cause any damage or ruin them for good! For basketballs that are rubber-based, there’s really no need to worry unless they’re extremely old (and therefore brittle).

What You’ll Need When Deflating a Basketball

Inflation Needle

You can find these almost anywhere! They’re cheap, so it won’t break the bank to buy one. Plus, they come right away when you order them online from Amazon too. “

Warning! I’ve seen posts on the web claiming that paper clips and other things can be used to place in your air valve. This is a risk because there’s no telling what will happen if you use these products. They might permanently harm your basketball, and this would make inflating it very difficult, or even impossible for you. Therefore, please get one or two inflation needles instead; it’s easy enough (and inexpensive).

How Can You Deflate Your Basketball When You Don’t Have An Air Pressure Gauge?

The key to deflating a basketball without the right equipment is using an air gauge. Here’s what you should know if you’re unsure which type of air pump or deflation needle works best for this task, especially when doing so at home on packaged balls that need storage or transportation capabilities!

Step #1: Check Your Basketball’s Pressure.

You can tell when your ball is inflated too much by dropping it from about your rib level and seeing if it bounces up. If you get a high bounce, then you’re overinflating for sure!

Step #2: Your Inflation Needle Should Be Moist.

You need to use water, or your spit, to insert a needle. This will make it easier for the person to do so and prevent any damage if they weren’t moistened with something beforehand!

Step #3: Squeeze the air valve with the needle.

Insert the needle into the ball’s air valve without using an air pump.

Step #4: Allow air to escape.

The air should be coming out of the ball at this point. You may have to squeeze the ball once it is partially deflated if you are trying to deflate it for storage or transit. This will aid in the removal of additional air.

You don’t want to leave the needle in for too long if you’re only attempting to lower the air pressure. It may only take a second or two, depending on how much air you need to remove.

Step #5: Take the needle out.

Once you feel like there is enough air, pull out your needle and remove it straight from its valve!

Step #6: Double-check the air pressure.

You can skip this step if you’re deflating for storage or transport. Check the air pressure before altering the inflation level. If it’s still too high, go back to step 2 and continue the process.

When you let out too much air, it can be underinflated by adding more until there is a good bounce.

You may need to use a pump to add more air if you let out too much air and it is now underinflated.

Carry on in this manner until you achieve a solid bounce.

Storing Your Basketball


Storing Your Basketball

Cleaning your basketball on a regular basis will help keep it in good form, but it isn’t the only thing you should do to keep it in good repair. It’s tempting to leave your ball in the backyard after practice, but sunlight, rain, and snow can cause significant damage.

Keep your basketball inside, at the very least. The best location to keep it is in a cold, dry place with a hanging bag. A basketball can be deformed by any weight forced against it, so avoid throwing it into a bin with a lot of other objects around it.


Basketballs are more expensive than ever. If you find yourself in a situation where your basketball needs deflating, don’t worry! The pointers we have listed should help get things back on track.

Leave a Reply

Your email address will not be published. Required fields are marked *